Place LED through the holes at the top of the mountain.  The engraving pattern shows that the flat side of the LED should be towards the bottom.  When you flip the badge around the long leg should be going through the top hole and the short leg should be going through the bottom.

Once the LED is in, slightly bend the legs and wrap the wire around each leg. ​The cable with the white markings and clear dash in it is positive (top in the photo).  The unmarked cable is negative (bottom in the photo).

After the wires are wrapped around each LED leg, bend the legs completely flat.  Then go a little past half way and bend the legs over themselves to secure the wires.

Once the wires are secured place the battery in the battery holder.  Place the negative side down on top of the metal connector then close the lid to secure the battery.

Once the battery is in, place the adhesive dot on the back of the battery holder and secure to the back of your badge.

Add the binder clip to the top hole so you can hang your badge, turn on and enjoy the blinky light!!!