Notions Box Guide


Just grab some wood glue and 15 minutes later you have a finished project!  Pick your favorite fiber animal and put together this handy box to keep all your notions in one place. We have 9 designs available in fiberboard and in an aromatic cedar veneer, featuring:

  • Cormo
  • Corriedale
  • Jacob
  • Navajo-Churro
  • Rambouillet
  • Wensleydale
  • Alpaca
  • Llama
  • Silk Moth

This is a collaboration with Sincere Sheep who had these illustrations made for her beautiful project bags.  More designs are coming soon, if you have a favorite that you don't see yet, let us know.

We sell these as kits because we like keeping an element of making in our products, plus it keeps the shipping cost low for you.  Full photo instructions are linked below.


Printable Instructions

Unpack your Kit

Each kit has the following items included:
1 - Unassembled box
2 - Adhesive backed magnets

Glue left & back panels to base

Place your box base on a flat surface. The base can go in any orientation you prefer. Take the left panel making sure that the hole is towards the back. Place glue along the indented side of the base and the left panel. Line up and hold until secured. Then, place glue along the indented sides of the back panel.

Place lid in holes & glue right panel

Place the tab on the lid through the hole on the left panel. Apply glue to right panel and line up, making sure the hole is towards the back. Place the other tab on the lid through the right panel. Let the lid rest on the base.

Glue front panel

Apply glue to the front panel. Lift up the lid and place front panel. Once front panel is in place, let the lid rest in the notch on the top of the front panel.

Clean off excess glue

Wipe off excess glue and let dry.

Attach magnets

Remove the paper covering the adhesive on the magnets. Magnets can be used to either secure the lid or you can place them anywhere in the box to secure sewing needles. To secure the lid, place one magnet centered below the notch on the front panel. Place the other magnet on the lid lining up with the magnet on the front. *Note: once magnets are applied please allow 24-36 hours for adhesive to reach full strength, you may want to keep the lid open for a day
Have any questions?  Contact us!